Hello - I have tried looking in all the documentation, but I cannot find anywhere that describes some of the features of the irclient syntax. I would specifically like to be able to send a command from the linux command line to a irTrans LANcontroller XT on one LED only. I've found the following from just calling irclient with no parameters:
usage : ./irclient <ip>
send : ./irclient <ip> <remote> <command>
send : ./irclient <ip> <remote> <command> <sendmask> <bus>
send : ./irclient <ip> <remote> <command> <sendmask> <bus> <led>
shutdown : ./irclient <ip> -shutdown
reload IRDB: ./irclient <ip> -reload
Flash IRDB : ./irclient <ip> -flashirdb <bus number> <actionstring> <remotelist>
Load IRDB : ./irclient <ip> -loadirdb <bus number> <filename>
receive : ./irclient <ip> -receive
Send RS232 : ./irclient <ip> -rs232send <data>
switch : ./irclient <ip> -switch <switch> <value>
LED : ./irclient <ip> -led <mode> <value>
But this doesn't tell me what format the sendmask, bus or led parameters should be in. Since I only have one irTrans device (the LANcontroller XT) I don't know what to use for bus or sendmask. I assume I can just give a number for led (like 4 - 11).
Thanks,
Kreig