Hello,
I have an IRTrans LAN I/O and all was working well, until today!.
I'd like to receive translated commands via UDP, elsewhere. In the IRTrans's web interface 'IP Relay' settings, I set UDP Broadcast Target and UDP Broadcast Port (NOT 21000 or 21001) to those of my UDP listener code, database size set to 64k for IRDB and translation to work in parallel. Flashing is fine, UDP strings are received. After adding some more IR translations today, for some commands the UDP message is never sent. This is confirmed via Wireshark, my code is not relevant, nor are there any firewall issues.
I started again with a blank IR Translation, then added 3 translations - 3 different buttons, 3 different target translations, each set to confirmed-working IR remotes. All fine. After adding a 4th translation, in exactly the same way, now none of the translations results in a UDP message. After starting again and getting to 4 translations, only 1 translation fails to send UDP data. I can't find a repeatable pattern for what stops UDP sending working.
Buttons in the IRDB but for which no translation is set at all, always do arrive as UDP at my server. 'Detected IR Commands' *always* reports the translated commands. Nothing in any of the translations is configured a different way. All remotes used in the translations are selected in the IRDB before flashing.
The LAN/IO hardware version is 1.5 with IR version E6.08.42 and LAN Version L1.11.06. The IRServer software version I'm using to program is 6.10.17 - but this would not normally be running.
Any ideas?
Thanks,
Fred