I have one problem with the combination of the IRtrans software in combination with MythTV.
I have an OrigenAe S10v enclosure, which has the following IRtrans module they call:
VF210 VFD/IR Module.
I installed Gentoo Linux (kernel 2.6.27) on the hardware I purchased, being:
M3N78-EM Asus motherboard.
Currently I am able to control MythTV completely with different remote controls ( The Philips RC197 Vista remote delivered with the S10V and a Logitec Harmony one). I can power on and off the system with the remote, I am able to change the boot message of the VFD and I am able to use both MythTV and Mplayer completely with the system.
I can also use the irw, irexec and irxevent commands.
When I use the debug mode of the irserver application or the irw application and I press buttons in the remote, only one output line is shown.
For example for the arrow down button irw is showing : 7500c380e3000000 00 down mediacenter
When I use irserver in debug mode with : irserver -codedump -debug_code -loglevel 4 /dev/ttyUSB0, I get the following:
....
Version : D5.08.10
FW SNo : 13898
....
IRServer Version 6.01.04
....
[0.0] down mediacenter
This all seems good to me, but when I am in the MythTV application and use the remote control in an Line Edit Field, pressing the arrow down button on each of the remotes generates a question mark. This is not what it is supposed to do, while it should just navigate through a displayed virtual keyboard. Also all other buttons like up, right, left, ok etc. generate a question mark in this case.
Both following lirc config file combinations generate the question mark in the above described case:
begin
prog = mythtv
button = down
config = Down
end
begin
prog = irxevent
button = down
config = Key Down CurrentWindow
end
My question is:
Could you please give me some hints what I could do, to find the cause of this behaviour?
For extra information I attached my current lirc and mediacenter.rem files, both are in the attached rar file.
Best regards,
Paul.