IR TRANSLATOR V 2.0 does not translate

Using the IRTrans IR Translator

Moderator: marcus

IR TRANSLATOR V 2.0 does not translate

Postby alfiomantiineo » Sun 7. Mar 2010, 20:47

Hi

I own a IR Translator V2.0
It was not used for some time, now I was trying to use it to translate the Bang & Olufsen BEO4 command to an old Dreambox.
The dreambox remote gave me some problems so I used the raw signal.

I tested the correctness of the data acquired using the "send" command of IR TRANS GUI Client and everything worked correctly.

After I flash the translator I get the green led to notify it received the signal but no signal is send to the dreambox.

Any suggestions ?
alfiomantiineo
 
Posts: 1
Joined: Sun 7. Mar 2010, 19:13

Re: IR TRANSLATOR V 2.0 does not translate

Postby IRTrans » Mon 8. Mar 2010, 22:35

It looks like either the Translation table is not correct or you are using the wrong B&O Command.

Please check with "Received IR Commands" if the B&O Commands are detected correctly.

IRTrans
IRTrans
Administrator
 
Posts: 2115
Joined: Mon 21. Apr 2008, 23:32


Return to IR Translator

Who is online

Users browsing this forum: No registered users and 1 guest

cron